The material used for the Syncshield is TPU (thermoplastic polyurethane). This material has excellent weather resistance, elasticity and flexibility
Scratch Resistant Performance
The strong 150μm polyurethane film protects your bicycle from external damage such as scratches and rubbing.
VIDEO
Fading Prevention Performance
Not only the polyurethane film, but also the coating layer and adhesive layer have the ability to block UV rays and protect your bicycle from fading.
Self-healing Performance
Since the Syncshield has the function of self-healing the film itself, it is possible to almost prevent the occurrence of small scratches. If it is a slight scratch such as a slight rubbing, it will repair itself.
VIDEO
Antifouling performance
The coating layer applied to the surface of the polyurethane film has the effect of preventing the sticking of mud and dirt that adheres daily.
Water repellency
Syncshield has excellent water repellency. The result of water contact angle test was 110°
VIDEO
Transparency
It has been developed with a high degree of transparency so as not to spoil the color texture of the bicycle itself. Even after the application, you won't notice that the film is glued on
Non-yellowing performance
The Syncshield uses a special urethane material that does not yellow. There is no obvious yellowing like general urethane materials.
Flexibility
It was developed to follow complicated cubic curved surfaces without difficulty. Achieves high workability.
Set contents and application section/parts
The set contents of this product are [190 mm x 580 mm 2 sheets].
Feel free to use it in places where scratches are likely to occur, such as top tubes, down tubes, seat tubes, and front forks.
Also used in all SENSHA Bicycle shops - the bicycle washing specialist.
At each SENSHA Bicycle store, which specializes in bicycles and coatings nationwide, we apply protection films on a daily basis. The protection film used there is this product Syncshield.
With the support of many customers, we have constructed many bicycles. Please give it a try!
1) The Syncshield has 3 layers at the time of shipment. Peel off the protective film with the round sticker on it.
2) Clean the area where the Syncshields attached to thoroughly remove dirt and oil.
3) Cut the Syncshield according to the location of the frame to be constructed. Since curved surfaces of pipes are prone to wrinkles, you can prevent wrinkles by cutting them into small pieces or making cuts.
4) Peel off the Syncshield from the mount while spraying our dedicated Syncshield construction liquid.
5) Spray the special construction liquid on the construction part of the frame and place it so that the Syncshield can be placed on it.
6) Using our rubber squeegee (hard / small), carefully push out the water remaining in the gap between the Syncshield and the frame so that no air bubbles remain. Adhesive strength is exhibited when water is removed. When doing this, wipe the surface of the Syncshield with the construction liquid to make the squeegee slippery and easier to work with. It is completed when enough water and air bubbles are removed.
※ When constructing, be sure to use the dedicated syncshield construction liquid. If you use a liquid other than the special construction liquid, we cannot guarantee the product.
VIDEO